Remove the 2 set screws for the ozone fan mounting platform. Conversely, contact is made by setting the belt cleaner motor to on and rotating the cam. Make sure no power is being supplied to the unit. Ordinary plain paper prevents the light from entering the photo sensor, and it is there- fore not detected as OHP film. If the printer is transported without removing the toner cartridge, the vibration will cause toner to fall onto the laser lens cover. Does it operate when the power supply is turned on? Is the tab on the one-way clutch for the transport roller worn?

Uploader: Gut
Date Added: 9 November 2012
File Size: 13.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 97196
Price: Free* [*Free Regsitration Required]

At first, I thought the pad somehow affected the timing by allowing the lever to rest ever so slightly in a further position from the solenoid.

Konica Minolta magicolor DL Drivers Download – Update Konica Minolta Software

Remove the left-rear cover. Remove the 2 fusing contact motor set screws. Each push of SW1 switches in following sequence: Interest will be charged to your account from the purchase date if the balance is not paid in full within 6 months.

The devel- mgicolor toner image is transported to the image transfer belt.

  HDTV USB DVB-T BDA DRIVER

Yes Replace the paper exit sensor PC 8. Ordinary plain paper prevents the light from entering the photo sensor, and it is there- fore not detected as OHP film.

Drum Reset Kit Konica Minolta QMS Magicolor 2200 2210 Color Printer 1710476-001

How satisfied are you with this reply? Yes Clean the timing roller. Lateral lines mm spacing. Remove the topmost paper guide 2 clips 6. Ensure the connection of the connector PJ12A is secure. Bad connector connection laser unit. It takes approximately one minute from the start of the test until the passage of the paper is completed. Also, if the driver is for older operating systems, you can install the device driver in the Compatibility Mode.

Never determine a defect on a circuit board by touching it with your hand or a metal object. Desktop full-color laser beam printer Printing system: Remove the plethora of screws on the rear of the printer and remove the back cover.

Always use two people when removing the printer from its shipping package and when transporting it. For more recent exchange rates, please use the Qma Currency Converter. Stay updated via RSS. Release 4 nylon standoff clips from the board. Doing so could result in an electric shock.

  I550 CANON DRIVER DOWNLOAD

There is no paper any- where. Toner hopper This is the container that holds the toner. Always handle the circuit board by its insulated parts so that you do not touch the terminals or soldered sections.

Paper empty sensor 9 Paper exit roller Minolta is a trade- mark of Minolta Co. Ed Level 3 Expert Answers.

If LD2 does not change from on to off when VR1 is turned all the way to the left, that position is L. Use dp tip of a ballpen or other such object to lift up the paper while turning the rollers. Drive Transmission Gear Drive motors are not installed in this tray.

It has been mounted at the factory using a jig and the drive gears adjusted to ensure optimum gear meshing. Remove one plastic c-clip and the brass bushing from the rear side of the registration roller. Tampering with these screws could image defects or abnormal minlota.